Home
About Us
Product
News
Marketing Network
Quality
Contact Us

Products

PRODUCTS

GT series

Classification:

Angular stroke actuator

Product Introduction

The GT series pneumatic actuator is a model that outputs torque with an angular stroke by using compressed air as power and mechanical transmission through the piston rack and pinion. The product is small in dimension, lightweight, has a long service life, and has high performance. It is divided into double-acting and single-acting (spring return). It applies to the on/off and adjustment of the angle stroke control valves (such as ball valves or butterfly valves) and can also be used for other situations requiring rotation.

online message

Product Introduction

● GT Series Actuators

Working pressure：Double-acting: filtered, dried or misted clean air

Working pressure：Double-acting：0.2~0.8MP

Operating temperature：

Normal temperature type：(Use the NBR O-ring)-20°C~ +80°C

Low-temperature type:(Use the silicone rubber O-ring) -40°C~ +80°C

High-temperature type:(Use the fluororubber O-ring) -20°C~ + 180°C

Rotation angle：Standard type：0°~90°± 5°

Output torque：Double-acting：0~9139N.m

Air source interface：G1/8", G1/4", G1/2"

Number of using high-temperature type：100000 cycles

No.	Name	Q’ty	No.	Name	Q’ty
1	Housing	1	12	O-ring above shaft	1
2	Piston	2	13	O-ring for bolts	1
3	Rotating shaft	1	14	Piston O-ring	1
4	End cap	2	15	End cap seal ring	2
5	Spring / Spring retainer	8~12	16	Piston guide ring	2
6	Lower bearing	1	17	Piston bearing	2
7	Snap ring	1	18	End cap plain washer	2
8	Washer in the shaft	2	19	Adjusting bolt	2
9	Upper bearing	1	20	Hex nut	2
10	Plain washer above shaft	1	21	Hex socket bolt	8
11	O-ring under shaft	1	22

Key words:

Extraordinary valve